Description
- Main Control Chip – The main control board uses 32-bit ARM-level Cortex-M4 series STM32F407ZET6/ STM32F429ZE / STM32F446ZE chip with a frequency of up to 168MHz and the flash is 1MB.
- Support 60V Input – Supports up to 8 3D printer motherboards with a maximum 60V stepper motor. The motor drive power supply supports up to 60V input (only for the motor drive power supply).
- 6 Controllable Fans – Up to 6 controllable fans, two normally open fans, and both support power supply voltage, 12V, 5V options.
- Update Firmware: Klipper/Marlin/RRF – Supports firmware update via DFU mode. This is where the firmware is sent to the board directly from the PC and does not require a bootloader however this method is not recommended for novice users as discussed later in this document.
- Level conversion IC – Supports proximity sensor, jumper optional pull-up resistor, supports more models, supports BL Touch.
- Wiring diagrams, pinout designations and all additional information can be found here on BTT SKR Pico Github repository here:
Motherboard Size
Wiring Diagram
Additional information
| Weight | 0.35 kg |
|---|
2 reviews for BTT BigTreeTech Octopus PRO V1.0 Mainboard STM32F446
Only logged in customers who have purchased this product may leave a review.
Dan Burns (verified owner) –
Upgrade from my dual SKR1.3 turbos to this and I’m using it with the USB-to-CANBUS bridge feature of Klipper for a CANBUS toolhead, works flawlessly. Everyone should use these for a Voron
thebeardedjake (verified owner) –
Great quality board and fast postage for when you need it. Thanks!